Roca Euret Manual Del Usuario página 6

5 Installation procedure
Install panel and battery (A35945E..0 , A35945S..0)
Take out the panel kit and battery kit from accessory box. Follow the below diagram to put in four AA batteries.
2
1
4
Install panel and battery (A35945E..0 , A35945S..0)
Push the power supply into the control box.
• Pay attention to the installation direction and keep the control wire downward.
• Pay attention to the connection of the connector , and make sure the connection is proper to avoid circuit problem and
failure of water-proof function.
• Be aware of the direction of cable connection, it should not be forced when installed.
Use a screwdriver to screw the panel to the control box, and finally insert the IR filter into the panel to finish the installation.
• Pay attention to the installation direction and keep the control wire downward.
• Pay attention to installation direction of the IR filter.
• Do not push or drag the IR filter forcefully to avoid damaging.
NOTE:
In case of maintenance, insert a needle (Not included) into the hole of IR filter and remove the IR filter. Use a screwdriver to release
two screws and remove the panel.
• Please be aware of the positive and negative electrode direction of
• Without sealing the battery case firmly, this will affect the use, water-
3
• The internal part of battery case required to be remained dry.
• New and old batteries should not be mixed for usage.
battery. The raised part of battery case should be aligned with the slot
of battery case.
proof capability and life of product.
Install panel and AC Power Assembly (A35945M..0 , A35945T..0)
6