Balanced Body Cadillac Manual De Instrucciones página 4

PARTS LIST (INCLUDED):
DESCRIPTION
Ankle Velcro (pair)
Cotton Loop (pair)
Long Web (pair)
Thigh Velcro (pair)
Wool Fuzzy (pair)
Roll down bar
Belly Strap
Red Trapeze Spring
Yellow Trapeze Spring
Blue Trapeze Spring
Long Yellow Trapeze Spring
Long Purple Trapeze Spring
Black Trapeze Spring (attached to
trapeze bar)
Safety Strap
Trapeze Bar w/Springs and Sling
Vertical Slider
Horizontal Slider
1/8" Cotter Pin
3/16" Allen Wrench
Push Through Bar for Slider
Assembly
Push Through Bar Slider Assembly
Push Through Bar Slider Shoulder
Bolt
Push Through Bar Slider 4th Side
Button Head Screw with Pin End
21mm x 1/2" wrench
7/32" Allen wrench
3
PART NUMBER QTY.
1
101-001
101-005 1
101-026 1
101-020 1
101-022 1
710-010 1
1
210-034
SPR9001 2
SPR9002 2
2
SPR9004
SPR9006 2
SPR9461 2
SPR9005 2
1
210-058
950-059 1
TRP6002 1
TRP6003 1
4
216-000
GEN9280 1
707-287 1
N/A 2
2
619-202
TRP0108 1
619-200 2
ALL0060 1
1
TOL1358
ASSEMBLE THE TRAPEZE CANOPY
1. Using the provided 3/16" allen wrench, loosen the set screws
in each of the eight flange connectors mounted to the outside
of the frame. Remove the two vertical tubes from the box
and the sliding push thru bar system. Lay the tubes down
so the holes on the sides of the tubes face away from each
other. Take the sliders of the Push Through Bar (PTB) and
slide them over the tubes opposite the end with the eye bolts,
you will need to pull the knobs of the sliders out to move the
sliders up the tubes. Continue to move the sliders up the
tubes until the pins lock into the bottom set of the three holes
in the tube. Make sure both sliders are locked into the same
bottom holes. Insert the provided cotter pins into each of
the 1/8" holes near the bottom ends of the tube. Pick up this
assembled tube set, be careful of the PTB, it may swing; place
the assembly in the flanges on the head end of the machine
(the end with the vinyl flaps). Be careful of the cotter pins so
they do not scratch the vinyl or wooden frame. The cotter pins
will automatically set the tubing height.
Insert the provided cotter pins into each of the 1/8" holes near
the bottom ends of the other two vertical tubes. Pick up the
tube assembly with the vertical slider and place the tube ends
into the flanges on the foot end of the frame.
2. Now set the canopy top onto the four vertical tubes. You will
need help with this. The end of the canopy frame with the
black safety strap goes over the push-through bar. Be certain
all four corner fittings fit securely over the tubes.
3. Using the 3/16" allen wrench, tighten the set screws in the
corner fittings and in the flanges around the frame. After
tightening all set screws in all the corner angles, test the
movement of the sliding push thru bar. To do this pull the
knobs of the sliders out and start sliding the PTB up or down.
This system should move easily and not stick when uniform
pressure is applied on each side. If the sliders stick when
moving the position, simply loosen the set screws that are
holding the vertical poles, rotate the tubes as necessary until
the sliders move freely. Be sure to re-tighten all set screws.
Remove the cotter pins from the tubes and save for future
use.