TECNOMOTOR ZIPTEC II TM 530 Manual De Instrucciones página 97

TM 530
Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar [email protected]
5 - Realizations angle measurements of permanence
Turn on the connection to the probe connector accessories Ziptec.
Position the switch on Pulse function.
Press until the screen angle measurement of permanence (Dwel).
Connect the black clamp to a grounding point, as the negative pole of the vehicle
battery.
Touch the probe Ziptec the wire or terminal to be measured and to keep in touch
(usually the negative terminal of the ignition coil).
The permanence value of the angle in degrees is shown. Also note that the bar
graph is shown.
Note: The trigger level for measuring angle of stay is 5V.
95