Using The Oscilloscope - TECNOMOTOR ZIPTEC II TM 530 Manual De Instrucciones

Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar [email protected]
1 - Menu Navigation
To navigate the menu oscilloscope setup follow the procedure below.
Connect the Ziptec.
Place the selector switch in the function Osc.
Press the key
lower left corner of the screen.
The key
(probe clever) stp (step by step) and con. (continuous).
Press the key
The key
Press the key
The key
division.
Press the key
The key
( ) rising edge.
Press the key
The key
small line on the vertical axis of the graph.
Press the key
In the "secondary ignition" with connections clamps connected to the accessory
connector Ziptec, with key connection clamps positioned SEC, the settings are a
little different. Follow the procedure below.
Connect the Ziptec.
Place the selector switch in the function Osc.
Press the key until the field "oscilloscope operation" flashes in the lower left
corner of the screen.
The key
step) and con (continuous).
Press the key
The key
Press the key
The key
division).
Press the key

Using the Oscilloscope

until the field "oscilloscope operation" flashes in the
allows you to select the operating mode between aut,
. The value of the time base will begin to flash.
allows you to change the value of the time base.
. The amplitude value will blink.
allows you to change the value of the amplitude in volts per
. The trigger type indicator will blink.
lets you select the type of trigger: ( )falling edge, (M) manual,
. The trigger adjustment indicator will blink.
allows you to change the trigger level which is indicated by a
. The oscilloscope will be active again.
allows you to select the operating mode between stp (step by
. The value of the time base will begin to flash.
allows you to change the value of the time base.
. The amplitude value will blink.
allows you to change the value of the amplitude (3kV or 6kV
. The trigger type indicator will blink.
TM 530
101