TECNOMOTOR ZIPTEC II TM 530 Manual De Instrucciones página 104

Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar [email protected]
The key
static ignition positive (ET-) static ignition and negative (PI) inductive clamp.
Press the key
The key
small line on the vertical axis of the graph. This setting is not used to trigger the
clamp inductive (PI).
Press the key
2 - Input Connections
For most measurements connection is required to probe, connected to the
accessory connector Ziptec (1). The black cable clamp (2) must be connected to
a ground point on the vehicle as the negative pole of the vehicle battery.
The measurement is made by the probe can be advanced and retracted by
turning the plastic ferrule (3).
You can also use the red probe to (4) that accompanies the kit Ziptec, connected
to the positive terminal of the connection to the probe.
Never use the probe Ziptec (3) and external probe (4) at the same time. As the
two are interconnected,
measurements may damage the equipment.
Measurements of secondary ignition connection is required in connection clamps
(5) connector accessories Ziptec.
lets you select the type of trigger: (vv) candle candle (ET +)
. The trigger adjustment indicator will blink.
allows you to change the trigger level which is indicated by a
. The oscilloscope will be active again.
short
TM 530
circuits generated
102
accidentally during