Changing The Broil Orifice, On Gas Ranges Only - Thermador Pro Harmony PALPKITHW Manual De Instrucciones

Changing the broil orifice, on
GAS ranges only (PRG models)
9 CAUTION
After the replacement of the broiler orifice, and
before reassembly of the back panel and backguard to
the range, perform a brief gas leakage check of the
orifice and associated fittings, per the "Check for Gas
Leaks" section of these instructions.
NOTE: Dual fuel (PRD models) ranges have electric
ovens and do not have a broil orifice.
Description Main oven broil Aux oven broil
Pro Grand 1.25 mm (125)
Pro Harmony 1.25 mm (125)
Removing the backguard assembly
1. Use a T-20 torx screwdriver to remove the screws from
the front and rear panel of the backguard assembly.
2. Carefully lift the backguard assembly from the range.
0.813 mm (813)
Changing the broil burner orifice
0.813 mm (813)
1. Remove broil orifice using a 7/16'' box end wrench,
NOTE: The replacement broil orifices have straight
threads (not tapered threads) and DO NOT require thread
sealing compound.
2. Perform a gas leakage check of the orifice and
while restraining the elbow fitting from rotation using
a small adjustable wrench.
IMPORTANT: DO NOT bend the broil burner orifice
bracket. Ensure that the broiler orifice is aligned to the
center of the burner tube inlet.
associated supply tube fittings, per the "Check for gas
leaks" section of these instructions.
Page. 13