Safety Information For Circular Saw Blades; Original Accessories/Auxiliary Equipment; Before Use; Removing/Charging/Inserting The Battery Pack - Parkside PHKSA 12 A1 Manual De Instrucciones

■ Do not allow the teeth of the saw blade to
overheat.
■ When sawing plastic, avoid melting the plastic.
■ Wear a dust mask when sawing.
■ Only use recommended saw blades.
■ Always wear hearing protection!
Safety information for circular saw
blades
Wear protective gloves!
Wear a dust mask!
Wear protective goggles!
Wear hearing protection!
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries.
Original accessories/auxiliary
equipment
■ Only use the accessories and additional
equipment that are specified in the oper-
ating instructions and compatible with the
appliance.

Before use

Removing/charging/inserting the
battery pack
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
│ GB │ MT
■ 52
■
1. To remove the battery pack
2. Insert the battery pack
3. Insert the mains plug into the socket. The control
4. The green charge status indicator LED
5. Insert the battery pack

Checking blade guard functionality

♦
The blade guard
When letting go of the release lever for the blade
guard
original position.

Operation

from or connect

Fitting/changing the saw blade

Always remove the battery pack before changing
the saw blade
1. Set the cutting depth (using the locking screw
2. Swing the blade guard
3. Press the spindle lock button
NOTE
► The battery is supplied partially charged.
Before first use, charge the battery in the
charger for at least 1 hour. This guarantees
full battery performance. You can charge the
lithium-ion battery at any time without short-
ening its service life. Interrupting the charging
process does not damage the battery.
► If the battery overheats during operation, it
cannot be charged immediately. Allow it to
cool down first.
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
button and pull the battery pack
appliance.
charger .
LED lights up red.
that the charging process is complete and the
battery pack is ready.
Pull the release lever for the blade guard
far as it will go.
should move without jamming.
, it should automatically jump back to its
!
to the minimum position, 0 mm.
release lever and put the appliance down.
es) and hold it in.
if the
, press the release
out of the
into the high-speed
indicates
back into the appliance.
as
back using the
(until it engag-
PHKSA 12 A1
)