SP6768-1 PROTEAM 4 GALLON
PREVENTIVE MAINTENANCE
!
WARNING:
The following information is for use by qualified service personnel only and
provides guidance for troubleshooting and maintenance.
• Unplug the Vacuum when working on the motor or any electrical part.
• DO NOT lubricate the motor.
• DO NOT tie extension cord and power cord together. Doing so will result in
damage to both cords and will not be covered under warranty.
CARING FOR YOUR VACUUM
1. The ensure a valid Vacuum warranty, optimal performance and improved indoor
air quality, be sure to use genuine ProTeam Filters.
2. Check all filters before each use. Empty or replace the filters as necessary.
3. Wipe the inside and outside of the Vacuum with a cleaning agent after each use.
PROPER STORAGE
When the Vacuum is not in use, the Vacuum should be stored indoors and in a dry
location. Before storing your Vacuum, the tank should be emptied and cleaned.
The cord should be wrapped around the unit and the hose and accessories should be
stored as described in this manual. Accessories should be kept in the same area as
the Vacuum so they can be readily available.
1. If the Vacuum will not operate, check the following:
a. The power supply cord at the wall outlet
b. The power supply cord at the Vacuum
c. That the switch is in the "on" position and functioning properly
d. Confirm the wall outlet being used has power. Check the circuit breaker in
the building. If that is not the problem contact a ProTeam Authorized
Warranty Station.
2. If the cord is getting too warm, check to see that the cord does not exceed a length
of 50 feet at 14 gauge or 100 feet at 12 gauge.
3. If loss of suction occurs, check the following:
a. Check that debris is not plugging the hose and/or accessories.
b. Check and/or clean the pleated filter.
c. Check that the hose cuffs are fitting tightly on the hose and are not cracked.
d. Check that the power head is properly attached to the Vacuum tank.
ProTeam
12/28/11
11:17 AM
TROUBLESHOOTING
Page 15
15