Technical Specifications - ResMed AirFit P10 Manual De Instrucciones

Problem/possible cause
Vent is blocked or
dirty/discolored.
Vent is wet.
Mask too noisy
System is assembled incorrectly. Disassemble the mask, then
System is leaking air.

Technical specifications

Pressure-flow
curve
Dead space
information
Therapy pressure
The mask contains passive venting to protect against
rebreathing. As a result of manufacturing variations, the
vent flow rate may vary.
Physical dead space is the empty volume of the
mask to the end of the swivel. Using the large
pillows it is 123 mL.
4 to 20 cm H
Solution
If the vent requires cleaning, use a
soft bristle brush. The vent may
discolor over time and this is not a
safety concern. Follow the cleaning
instructions in this guide to maintain
performance and safety of the mask.
Ensure the vent is dry after cleaning
and in the case of excess
condensation.
reassemble according to the
instructions.
Refit or reposition your mask. Adjust
your headgear. Check your mask is
assembled correctly.
O
2
Pressure Flow
(cm H O) (L/min)
2
4 20
8 29
12 37
16 43
20 49
English
7