Step 8: Check Installation; Moving Unit To A New Location; Reinstallation Of Shipping Materials; Electrical Requirements - Alliance Laundry Systems H370I Guia De Instalacion

Step 8: Check Installation

Refer to Installer Checklist on the back cover and
make sure that unit is installed correctly.

Moving Unit to a New Location

To prevent damage while moving the unit, the
shipping materials MUST BE reinstalled.

Reinstallation of Shipping Materials

Disconnect washer from electrical supply.
Remove front access panel by removing two screws.
Place the shock sleeves on all four shock absorbers.
Refer to Figure 14.
Insert hooked end of shipping brace into the open slot
of the motor mount. Attach with bolts and lockwashers.
Refer to Figure 14.
Reinstall front access panel.
4
3
1 Shock Sleeves
2 Motor Mount
3 Bolts and Lockwashers
4 Hooked End of Shipping Brace
Figure 14
Refer to step 5 for proper procedures whenever the
unit is moved.
801561
1
2
H336I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Electrical Requirements

NOTE: The wiring diagram is located behind the
control panel, inside the control hood.
WARNING
To reduce the risk of fire, electric shock,
serious injury or death, all wiring and earthing MUST abide with local electrical
codes. It is the customer's responsibility to
have the wiring and fuses checked by a
qualified electrician to make sure the
laundry room has adequate electrical power
to operate the washer.
DO NOT OVERLOAD
CIRCUITS
DO NOT USE AN
ADAPTER
DO NOT USE AN
EXTENSION CORD
Figure 15
NOTE: Refer to the washer nameplate for proper
voltage and Hertz the washer is designed to operate
on. Refer to Figure 16.
1 Nameplate
Figure 16
Installation
W246
D009I
1
H129P
13