Water Temperature; Water Pressure; Risers - Alliance Laundry Systems H370I Guia De Instalacion

Installation

Water Temperature

Cold:
Recommended cold water temperature is 16° to
27° Celsius (60° to 80° Fahrenheit).
Hot:
Recommended hot water temperature is 49° to
60° Celsius (120° to 140° Fahrenheit).
Warm:
Mixture of hot and cold water (warm water
temperature is dependent upon the water temperature
and the pressure of both the hot and cold water supply
lines).
IMPORTANT: Turn off water supply faucets after
check-out and demonstration. Owner should turn
off water supply whenever there will be an
extended period of non-use.
NOTE: Longer inlet hoses are available (as
optional equipment at extra cost) if the hoses
(supplied with the washer) are not long enough for
the installation. Order hoses as follows:
No. 20617 Inlet Hose (2.44 m) (8 ft.)
No. 20618 Inlet Hose (3.05 m) (10 ft.)
1
4
1 Water Supply Faucets
2 Cold Water Connection
3 Hot Water Connection
4 Water Inlet Hoses
Figure 18
16
2
WATER
MIXING
VALVE
3
FLW2008N
FLW2008N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Water Pressure

Pressure must be a minimum of 138 to a maximum of
827 kPa (20 to 120 pounds per square inch) static
pressure measured at the faucet.
NOTE: Water pressure under 138 kPa (20 pounds
per square inch) will cause an extended fill time in
the washer and may not properly flush out the
detergent dispenser.

Risers

Risers (or air cushions) may have to be installed if the
pipes knock or pound when flow of water stops. The
risers are more efficient when installed as close as
possible to the water supply faucets (refer to Figure 19).
1
1 Water Supply Faucets
2 Risers (Air Cushions)
Figure 19
2
W005I
W005I
801561