Tabla de contenido
Idiomas disponibles
Idiomas disponibles
This manual is designed as a guide to the installation
and maintenance of the 135 pound and 250 pound
capacity cabinet freestanding washer-extractors.
The manuals, installation instructions, and the wiring
diagrams which accompany the washer-extractor have
been included with the machine at no charge.
Additional copies are available at a nominal charge.
NOTE: All information, illustrations, and
specifications contained in this manual are based
on the latest product information available at the
time of printing. We reserve the right to make
changes at any time without notice.
Machine Overview
The design of the washer-extractor emphasizes
performance and long service life. The cylinder, shell,
and main body panels are fabricated of stainless steel.
The washer-extractor features the WE-6
microcomputer which offers 39 preprogrammed
cycles and programming versatility in the field.
The AC inverter drive control provides programmable
motor speeds using a single motor. This makes it
possible to achieve ultra-high extract speeds.
Two separate bearings support the cylinder on
135 pound and 250 pound models.
The cylinder is constructed with four lifters or ribs that
lift the laundry from the bath solution when the
cylinder rotates at slow speed and then allow it to
tumble back into the bath. This mechanical action
accomplishes the cleaning function. The cylinder is
perforated, allowing the water to drain from within
during the wash and extract steps.
The supply dispenser is located on the left side panel
of the washer-extractor. The supply dispenser
compartments are accessed by unlatching the supply
dispenser cover door. These compartments accept
powder or liquid supplies. Each compartment is
controlled independently by the WE-6 computer.
F232102
Installation
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Electrical controls for the washer-extractor are housed
in three enclosures. The front control module is
located just behind the keypad and control panel. It
houses the WE-6 computer board, a fuse/relay board,
and other functional electrical components. The rear
control module houses the AC inverter drive and its
components.
A door-lock system prevents opening of the door when
water is in the washer-extractor. It also prevents
operation of the washer-extractor when the door is
open.
The doorbox contains the Hall-effect door-closed
sensor, door-open sensor, and the door-unlock
solenoid.
On 135 pound capacity models, water enters the
machine through electromechanical water valves. On
250 pound capacity models, water enters the machine
through pneumatic water valves on the rear of the
machine. (Pneumatic water valves are an option on
135 pound capacity models.)
Emergency Stop Button
On 135 pound capacity models, a red emergency stop
button is located on the right side of the washer-
extractor front. On 250 pound capacity models, the
emergency stop button is located on the left side. Push
the button to stop the machine.
Wet Clean Capable Features
The washer-extractor is equipped with the following
wet clean capable features: one-half wash speed for
gentle mechanical action during wash; eight supply
signals, providing normal laundering signals to
dispense detergents, bleaches, softeners, sours, etc.,
and also chemicals unique to wet clean processing.
9
Capítulos
Tabla de contenido
