Siemens 1FK6 Instrucciones De Servicio página 185

08.2009
Assembling and
mounting the unit
Designating the
optional board
Siemens AG 6SE7087-8JP50
SIMOVERT MASTERDRIVES
Close the right-hand side wall of the unit as follows
♦ Press the front panel slightly to the side and insert the side wall from
above into the unit. Make sure after inserting the side wall that the
fixing lugs mounted at the top and bottom of the side wall are on the
outside.
♦ Screw the side wall tight again by means of the four fixing screws.
♦ Place the unit on its rear wall.
♦ Press the front panel from above onto the now closed unit so that
you can hear its latches engaging.
Mount the unit as follows:
♦ Insert the unit into its mounting position from the front underneath
the DC link bus module.
♦ Lift the unit upwards until the DC link bus module is completely in its
original position again.
♦ Screw the unit tight to the mounting surface with the fixing screws.
♦ Interlock the DC bus module.
If you are using an AC unit as a single drive, you can fix the unit directly
to the mounting surface.
♦ Re-connect all previously removed connecting cables.
♦ Check all connecting cables and the shield to make sure they sit
properly and are in the correct position.
♦ To designate the optional board, insert the relevant designation
plate into the envisaged position on the front of the unit.
♦ After powering up the voltage, you can log on the optional boards in
the software of the unit and commence start-up.
Operating Instructions
Installation
5-7