Electrolux EOC55200 Manual De Instrucciones página 14

14 electrolux
Cleaning the door gasket
• Regularly do a check of the door gasket.
The door gasket is around the frame of
the oven cavity. Do not use the appliance
if the door gasket is damaged. Contact
the Service Centre.
• To clean the door gasket refer to the
general information about the cleaning.
Pyrolytic cleaning
1. Remove all parts from the oven.
If you do not remove the shelf support
rails, the clock display shows " AS "
and pyrolytic cleaning procedure can-
not start.
2. Remove the worst of the residue man-
ually.
3. Set oven function Pyroluxe menu
– " Pyro " appears in the display,
– Duration
flashes for approximately
5 seconds.
The pyrolytic cleaning process lasts ap-
proximately 2,5 hours. If you want it to
end at a specific time, press the Selec-
tion button until the End
dicator flashes. Use the + / - control
knob to set the end time for the proce-
dure. The function calculates the start
time based on the end time you speci-
fy. The pyrolytic cleaning then starts
and ends at the required time.
4. Press the Pyro button. Pyrolytic clean-
ing starts.
5. At the end of the process, an accustic
signal sounds and " 0.00 " appears in
the display. Duration
proximately 5 seconds. Turn the oven
control knob to 0 .
During pyrolytic cleaning the light does
not operate.
When the oven reaches pre-set tem-
perature, the door locks.
The bars of the heat indicator come up,
until the door unlocks again.
Shelf Support Rails
Removing the shelf support rails
1. Pull the front of the shelf support rail
away from the side wall.
2. Pull the rear shelf support rail away from
function in-
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
Oven lamp
flashes for ap-
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
1. Turn the glass cover anti-clockwise to
2. Clean the glass cover.
3. Replace the oven light bulb with appli-
4. Install the glass cover.
the side wall and remove it.
2
1
The rounded ends of the shelf support
rails must point to the front!
Warning! Be careful! There is the risk
of electrical shock!
switch off the circuit breaker.
Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.
remove it.
cable 300°C heat-resistant oven light
bulb.
Use the same oven lamp type.