Handling The Machine Without Packing - brevini RDF159 Manual De Instalación Y Mantenimiento

The strap holding the product to the packing
is sharp. It may hit the operator while the product is
being unloaded.
The packing must be eliminated as follows:
- use a pair of shears to cut the straps (warning: the
ends may hit the operator)
- cut or remove the external packing
- cut the internal strap (warning: the ends may hit
the operator)
- remove the machine from the pallets.
If the machine has been damaged or if there are
any defects or missing parts, immediately notify the
BREVINI . Service department: Tel. ++39.-522-9.28.1,
Fax ++39.-522-9.28.300.

4.4 Handling the machine without packing

Before removing the machine from its
packing make sure it is solidly attached to the
lifting accessories so that it cannot slide or flip over.
Before handling the machine, remove the wood
blocks inserted in the packing to keep it stable
during shipment.
Lift the machine making sure the load remains
balanced during the various operations.
4.5 Storage
If the product must be stored for more than 2 months,
do the following:
- Protect the shafts and the spigots with a film or
grease and/or rust-inhibitor liquids
- Completely fill the gear unit and any multi-disk
brake with suitable oil (see tparagraph 7..3)
-Store the machine in a cool place at a temperature
ranging from -5°C to +30°C
- Protect the packages against dirt, dust and
moisture.
NOTE: For extended storage of more than 6 months,
the rotating seals will no longer be efficient. It is rec-
ommended to check them periodically by turning the
internal gears by and rotating the input shaft. For a
negative multi-disk brake, release the brake by using
a hydraulic pump or similar device (see paragraph 9..
for the brake opening pressure). It is recommended
to replace the gaskets when the machine is started.
www.comoso.com 28.