Pre-Installation; Tools Required - AquaPRO 63013 Manual Del Propietário

PRE-INSTALLATION

APPLICATION
This unit is a convertible jet pump designed for pumping water where the water level is less than 70 ft. deep. If the water level
to the pump is deeper than 70 ft., a deep well submersible pump should be selected. A pressure switch pre-set at 30 psi "on"/
50 psi "off" has been installed on the pump. The pressure switch will automatically turn the pump on and off based on the
system pressure.

TOOLS REQUIRED

Flathead
Screwdriver
Safety goggles
SPECIFICATIONS
POWER SUPPLY
LIQUID TEMP. RANGE
DISCHARGE SIZE
SUCTION SIZE
SHALLOW WELL WATER LEVEL
DEEP WELL WATER LEVEL
DETERMINE THE DEPTH OF YOUR WELL
Tie a small but heavy weight such as a fishing weight to the end of a piece of cotton string. Lower the weight into the well until
it reaches the bottom of the well. Make a mark on the string at ground level. Pull the weight out of the well and measure from
the bottom of the weight to the ground level mark. This is the depth of your well. Subtract 5 ft. from the depth of your well. If
this number is less than 25 ft., shallow well installation should be taken. If this number is more than 25 ft. and less than 70 ft.,
deep well installation should be taken. If this number is more than 70 ft., a deep well submersible pump should be selected.
Measure the ground level mark to the mark where the cotton string is wetted. This number is your well's water level. It should
also be at least 10 ft. below the well's water level while the pump is running in order to prevent the pump from sucking air due
to water level drawdown.
Phillips
Screwdriver
Tape Measure
115V/230V, 60 HZ., 20/10 Amp Circuit
32° F to 77° F (0° - 25° C)
1 in. FNPT
1-1/4 in. FNPT
25 ft.
70 ft.
3
Pipe wrench
Thread Tape
Hacksaw
PVC glue