Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Thread the 1/4 in. elbow insert into the 1/4 in. hole on the side of the pressure regulator. Slide the pressure tubing
(attached with the pump pressure switch or included in regulator kit) over the 1/4 in. brass elbow and the pressure switch
connector.
6. Wrap thread tape around the threads of a 3/4 in. MNPT x 1 in. slip PVC adaptor (sold separately), and thread the
adaptor in the pressure regulator.
Discharge Pipe and Pressure Tank Connections
Wrap all threads with thread tape.
In order for the pump and the pressure tank (sold separately) to operate
properly, the pressure tank needs to be drained of all water BEFORE
INSTALLING IT TO THE PUMP.
Thread a 10 in. tank tee (sold separately) or another necessary size tee into the
pressure tank.
Plug one outlet on top of the tank tee with a 1/4 in. plug (sold separately) and
install a pressure gauge (sold separately) on the other outlet on top of the tank
tee.
Thread two 1 in. female PVC adaptors (sold separately) onto the two inlet sides
of tank tee.
Thread a 1/2 in. relief valve and a 1/2 in. drain valve (both sold separately) to the front of the tank tee.
Using PVC purple primer and PVC cement, attach a section of 1 in. PVC pipe (sold separately) as needed to connect the
3/4 in. MNPT x 1 in. slip PVC adaptor in the pressure regulator.
Attach another section of 1 in. PVC pipe (soldseparately) as needed to connect the other 1 in. female PVC adaptor on the
tank tee to the water system from the house.
13
Tabla de contenido
