Tabla de contenido
Idiomas disponibles
Idiomas disponibles
19. Ensure the electrical power source is adequate for the requirements of the pump.
20. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long time
when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or debris
may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.
PRE-INSTALLATION
APPLICATION
41011-3,41021-3 are submersible sewage pumps and designed for pumping sewage, effluent, wastewater or flooded
water with up to 2inch solids.
40011-3 is submersible effluent pump and designed for pumping, effluent, wastewater or flooded water with up to 3/4
inch solids.
The pump is built with overload thermal protections and auto reset. The pump is equipped with a 10' 3-prong
grounding-type power cord and tethered float switch. This pump operates automatically. Ball bearings on motor shafts
never need lubrication.
TOOLS REQUIRED
Flathead
Screwdriver
Cable Ties
MATERIALS REQUIRED (NOT INCLUDED)
Threaded Adapter
(Pipe to Pump)
2" check
valve
For Professional Technical Support call 1-844-242-2475
Phillips
Screwdriver
Safety goggles
2'' ABS or PVC
Pipe
ABS or PVC
Cement
(to match the pipe)
Channel
Locks
Tape Measure
Pipe wrench
Hacksaw
Thread Tape
2" 90°
Elbow
3
Tabla de contenido
