Tabla de contenido
Idiomas disponibles
Idiomas disponibles
18. The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The protector will
reset itself once the motor cools down and an acceptable temperature has been reached. The pump may start
unexpectedly if it is plugged in.
19. Ensure the electrical power source is adequate for the requirements of the pump.
20. Before using the pump, check the hose for holes or excess wear, which could cause leaks, and ensure the
hose is not kinked or making sharp angles. A straight hose allows the pump to move the greatest amount of
water quickly, and also check that all hose connections are tight to minimize leaks.
21. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long
time when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt,
or debris may cause the pump to fail. Please carefully read the manual and follow the instructions regarding
common pump problems and remedies.
PRE-INSTALLATION
APPLICATION
This submersible utility pump is designed for water removal applications. Pump water only with this pump.
It can automatically drain or remove water from the following: pits, sinks, window wells, basements,
swimming pool covers, boats, low spot in yards, or other flooded areas.
This pump has not been tested or approved for use in swimming pools or in salt-water marine areas. This
pump is not designed to function as a permanently installed sump pump. It is also not engineered to be run
continuously as a "fountain" or "waterfall" pump.
Do not use where water recirculates.
Not designed for use as a swimming pool drainer.
Function:
Operating water depth: minimum 1-1/2 in.
TOOLS REQUIRED
Flathead
Screwdriver
MATERIALS REQUIRED (NOT INCLUDED)
NOTE:
The hose and hose kit are not shown to scale.
Phillips
Screwdriver
Garden
Hose or
Hose kit
Wrench
3
Safety
Goggles
Sump
Pump
Discharge
Hose Kit
Tabla de contenido
Solución de problemas
