AquaPRO 63013 Guia De Inicio Rapido

Quick Start Guide
Model# 63013/63023/63033
Convertible Jet Pump
SHALLOW WELL APPLICATION (0-25 FT.)
1. Connect a rigid pipe to the foot valve. Connect the tee to the pipe,
and slide the pipe assembly into the well.Mount the pump as close to
the well as possible.
Connect the pipe assembly with pump and connect the pump with
water system.
Tank
To household
water system
Pipe
Flexible plastic
Check valve
pipe and clamps
Priming tee
and plug
Well seal
25 ft max.
Pipe
10 ft min.
Foot valve
Strainer
5 ft min.
2. Prime the pump and pipe.
Priming tee and plug
3. Voltage setting.
• This pump is pre-wired at 230 volts.
• If the power source is 115 volts, remove the
electrical housing cover.
• Flip the switch to 115 volts. Replace the cover.
electrical housing cover
DEEP WELL APPLICATION (25-70 FT.)
1a. Removing the pre-assembled ejector first then
removing the pre-assembled nozzle and venturi.
Install the included nozzle and venturi for deep well
application.
4. Connect the power supply wiring to the pressure switch.
• Remove the pressure switch cover on the pump to expose the wiring terminals.
• Connect the green ground wire of the power supply to the switch ground terminal.
• Connect the power supply wires to the two outside terminals marked "LINE" and
replace the switch cover.
1b. Connect the foot valve to the ejector. Connect the
rigid pipe to the ejector and slide the pipe assembly
into the well. Mount the pump as close to the well as
possible. Connect the pipe assembly with the pump.
Connect the pump with water system.
To household
Tank
water system
Pipe
Priming tee and plug
Flexible plastic pipe
Elbow
and clamps
Well seal
70 ft max.
Pipe
10 ft Min.
Nipple
Ejector (included)
Foot valve
5 ft Min.
Strainer
1
2
Power supply
and LINE
Ground connection
must be made at this point
Pressure regulator (included)
To motor lead
and LOAD