To Set The Static Correction Level; Anti-Linger Prevention; Run Through Prevention; Over Correction Protection - Petsafe stubborn dog in-ground fence Manual De Adiestramiento Y Funcionamiento

To Set the Static Correction Level

Read all steps before attempting to set the Static Correction Level.
1. Remove the clear plastic cover with the Test Light Tool to
expose the Correction Level Button (5D).
2. With the battery installed, press the Correction Level
Button and release when the Receiver Indicator Light
lights up (5E).
3. The Receiver Indicator Light will emit a series of flashes
representing the Static Correction Level.
4. Increase the Static Correction Level by pressing and
releasing the Correction Level Button within 5 seconds
of the previous series of flashes.
5. After setting the Static Correction Level, replace the cover
to protect the Correction Level Button.
The Static Correction levels increase in strength from 1 to 5. Pushing the Correction Level Button while the Receiver
Collar is on level 5 will cause the Receiver Collar to revert to Level 1. Refer to the Function and Response Table to
choose the Static Correction level that best fits your pet.
The Receiver Collar will emit a Warning Tone and vibrate whenever your pet enters the Warning Zone, no matter
what correction level the Receiver Collar is set to. If your pet continues into the Correction Zone, and the Receiver
Collar is set to level 2 or above, he will receive a Static Correction. The Receiver Collar is equipped to automatically
increase the level of Static Correction the longer your pet remains in the Static Correction Zone if the collar is set at
level 2 or above.
The Receiver Indicator Light acts as a low battery indicator, flashing every 4 to 5 seconds when battery replacement
is required. Test your Receiver Collar at least once a month to verify that it is functioning properly and that it
activates at the Boundary Wire.

Anti-Linger Prevention

The Anti-Linger Prevention feature keeps your dog from staying in the Warning Zone for long periods of time
and draining the Receiver Collar battery. Your dog will hear a warning tone when he reaches the Warning Zone.
If your dog does not return to the Pet Area after two seconds, he will receive a continuous Static Correction
until he returns to the Pet Area.

Run Through Prevention

This system includes a unique "run-through" prevention so that your dog cannot escape the Pet Area without
receiving an increased level of Static Correction. The Receiver Collar automatically increases the Static Correction
when your dog continues more than 20% of the way through the pet fencing Boundary Width. For example, if the
signal is detected 10 feet from the wire and your dog enters the Static Correction Zone, this feature is activated
when he is approximately 8 feet from the Boundary Wire. Your dog will then receive a Static Correction that is
at an increased level corresponding to the Static Correction level setting on the Receiver Collar. The Receiver
Collar is equipped to automatically increase the level of Static Correction the longer your pet remains in the Static
Correction Zone if the collar is set at level 2 or above. The Run Through Prevention sound is an intermittent tone.

Over Correction Protection

In the unlikely event that your pet "freezes" in the Static Correction Zone, this feature limits the static correction
duration to a maximum of 30 seconds. While the system locks out further static correction, the warning tone will
continue until the pet leaves the Static Correction Zone.
5D
www.petsafe.net
5E
13