Novellini Una Manual De Instalación, Uso Y Mantenimiento página 36

The pump will activate and the disinfectant soon begins
to circulate. After 4 minutes, the pump stops for about 20
minutes and then restarts for a further minute.
After this time, a symbol appears on the display to indica-
te that the bath is ready to be emptied.
If the image below is displayed at the beginning of the di-
sinfection process, and disinfection does not start, adjust
the level of disinfectant.
Another reason for the disinfection process to fail to start
may be that there is insufficient water in the bath. In this
case, the image below will be displayed.
Top up the bath with water to restart the disinfection pro-
cess.
Do not bathe in or use the water that has been
used for disinfection.
If the disinfection process is interrupted for any reason,
the disinfection symbol on the main menu lights up to
warn that disinfection has not been completed.
To cancel this warning, carry out a complete disinfection
cycle afresh.
Time adjustment menu:
From the main menu, press and hold the time button on
the display until the time adjustment sub-menu appears.
14 Press the + and - buttons to adjust the hours.
15 Press the + and - buttons to adjust the minutes.
16 Press to confirm and return to the main menu.
14
15
16
Alarm:
17 Communication failure between the central unit and
the remote control. Check that the power unit is switched
on. If it is not, contact the service centre.
17
02- Whirlpool Version with Airpool + Disinfection
Switching on:
Press the display and hold until the welcome screen ap-
pears.
Main commands:
1- Hydromassage
2- Disinfection
3- OFF (all active functions).
Hydromassage menu:
Press button 1 on the main menu to access the
hydromassage menu.
1
Select the hydromassage desired by repeatedly pressing
the relevant buttons 5 and 6.
Press button 7 to confirm and start the hydromassage.
To have the same hydromassage as last time, simply
press button 7 to start
the massage.
To change the duration of the massage, use the duration
sub-menu, which can be accessed by pressing button 4.
36
4
5 WHIRLPOOL
OFF
6 AIRPOOL
CONTINUOUS
OFF
Hydromassage duration sub-menu:
The + and - buttons can be used to alter the duration of
the massage.
Once the desired time has been entered, press 8 to con-
firm.
Press 7 if you wish to start the massage.
The display shows the remaining hydromassage time;
button 9 is lit to show that the massage is in progress.
9
NOTE: If the duration of the hydromassage is set to 0, the
massage will run for about 1 hour, starting from the last
command entered.
2
If there is not enough water in the bath, the symbol 10
will appear, at which point you will need to add water to
start the hydromassage automatically.
3
10
Whirlpool sub-menu:
Repeatedly press button 5 to select the Whirlpool fun-
ction.
ENGLISH
5
6
7
MANUAL AUTOMATIC
TIMED
8