Description Of The Remote Control /30 - Novellini Una Manual De Instalación, Uso Y Mantenimiento

ENGLISH

Description of the remote control /30:

Assembly/battery replacement:
Before inserting the batteries, ensure that the power unit
is switched on.
The batteries (supplied) are ALKALINE AAA LR03 1.5V
type. When they run out, they must always be replaced
by 2 new batteries of the same type.
Insert the batteries, being sure to observe the polarity.
WARNING: it could be dangerous for
No
pace-maker wearer.
pacemakers
Before closing the compartment, check to ensure that
the water-tight seal is still correctly in place.
Description of the remote control:
Once the batteries are inserted, the remote control
searches for the bath with which it will have to commu-
nicate.
The bath must therefore be connected to the power sup-
ply. To confirm that this operation has been carried out
successfully, shortly after the batteries are inserted, the
pump switches on for a few seconds.
Your remote control is now ready to use.
To optimise battery life, the display turns itself off 20 se-
conds after the last command entered. To restore it, gen-
tly press on any part of the display.
01- Whirlpool Version with Disinfection
Switching on:
Press the display and hold until the welcome screen ap-
pears.
Main commands:
1- Hydromassage
2- Disinfection
3- OFF (all active functions).
Hydromassage menu:
Press button 1 on the main menu to access the
whirIpool massage menu.
1
Select the hydromassage desired by repeatedly pressing
the relevant button 5.
Press button 6 to confirm and start the hydromassage.
To have the same hydromassage as last time, simply
press button 6 to start
the massage.
To change the duration of the massage, use the duration
sub-menu, which can be accessed by pressing button 4.
NO OK
4
OFF
Hydromassage duration sub-menu:
The + and - buttons can be used to alter the duration of
the massage.
Once the desired time has been entered, press 7 to con-
firm.
Press 6 if you wish to start the massage.
The display shows the remaining hydromassage time;
button 8 is lit to show that the massage is in progress.
8
NOTE: If the duration of the hydromassage is set to 0, the
massage will run for about 1 hour, starting from the last
command entered.
If there is not enough water in the bath, the symbol 9
will appear, at which point you will need to add water to
start the hydromassage automatically.
9
2
3
Whirlpool sub-menu:
Repeatedly press button 5 to select the whirlpool function.
Manual Whirlpool function:
Press and hold button 10 to adjust the intensity of the
whirlpool massage. Simply release the button to apply the
new setting.
5
6
MANUAL AUTOMATIC
Automatic Whirlpool function:
The massage intensity is varied to create a pleasant mo-
dulating effect.
You can return from the hydromassage menu to the main
menu using button 11.
Disinfection menu:
7
Press button 2 on the main menu to access the disinfec-
tion menu.
To start disinfection, once the bath has been cleaned, fill
the bath with clean water up to the level used during nor-
mal use.
Fill the disinfectant tank only on first use or when subse-
quently required, and press button 12 to release the sy-
stem.
Then use button 13 to start the disinfection process.
35
10
11
12
13