Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6.3
Operating modes
Description
Automatic mode:
− Operating mode for normal operation.
Time-dependent operation
6.4
Manual cleaning
How to proceed
Press for
3 s
− LED (6) is lit
− The display indicates CL
− To cancel the process: Press the button again
6.5
Settings in the menus
N O T E
Settings can only be made in the menus when the control system is switched on. (→ Switching ON/OFF)
6.5.1
CL: Cleaning time "Cleaning"
Setting the cleaning time changes the duration of the cleaning cycle. Extend the cleaning time if the dirt is
not completely carried away by the water, for example if the drain pipes are very long or have lots of
bends, or there is a particularly large amount of sticky dirt (e.g. during spawning).
Please take into consideration that an extended cleaning time leads to increased water consumption. The
default setting of 10 s is normally sufficient (corresponds to approx. a
Proceed as follows
1.
Press
several times until Cl appears in
the display.
2.
Press
for 5 s until the time is indicated in
the display.
3.
Press
several times to change the
value.
− To change the value quickly: Hold down
the button
Information
− The display indicates the water temperature as standard.
− A cleaning cycle is automatically started if the level detection device
signals an excessive deviation in the water level.
− The level exceeds a certain water level.
− After 20 automatic cleaning cycles, a cleaning cycle with extended
cleaning time is performed.
− In addition to the automatic cleaning cycle (dependent upon the water
level in the drum filter), a time-dependent cleaning cycle can be
performed. (→ In: Time-dependent cleaning "Interval")
− The duration of the cleaning cycle corresponds to the time set in the
cleaning time "Cleaning" menu. (→ CL: Cleaning time "Cleaning")
Information
− The drum motor is stopped for safety reasons if the filter cover is lifted.
The rinsing pump can still be manually started to check the function of
the nozzles.
− Each active cleaning cycle (automatic, time-dependent or manual) can
be stopped by pressing the button.
Information
− To cancel and exit the menu: Either wait for 10 s or press
− To cancel and exit the menu: Either wait for 5 s or press
− Settable range: 10 – 30 s
− Increment: 1 s
− The number can only be changed upwards. Once the value 30 is
reached, the display returns to 10.
− Saving the set value: Wait for 5 s until the menu is automatically exited.
− Cancel without saving and exit the menu:
7
/
drum rotation).
8
or press
- EN -
or
.
or
.
.
53
Capítulos
Tabla de contenido
