Ryobi P232 Manual Del Operador página 8

BUILT-IN COUPLER
See Figure 4, page 10.
The tool has a built-in coupler. The coupler has been de-
signed to accept 1/4 in. hex bits.
INSTALLING BITS
See Figure 4, page 10.
 Lock switch trigger on the tool by placing the direction
of rotation selector in center position.
 Slide the coupler forward and hold in position.
 Insert bit straight into coupler.
 Slide the coupler back slowly and release.
REMOVING BITS
See Figure 4, page 10.
 Lock switch trigger or the drill by placing the direction of
rotation selector in center position.
 Slide the coupler forward and hold in position.
 Pull bit straight out of coupler.
WARNING:
Make sure the bit is secured in the coupler before using the impact driver. Failure to do so could cause serious
personal injury.
CALIFORNIA PROPOSITION 65
WARNING:
This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may
contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive
harm. Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products and,
• arsenic and chromium from chemically treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your
exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially
designed to filter out microscopic particles.
OPERATION
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock
the operator. If you must drive a screw where hidden wire
may be present, always hold tool by insulated gripping
surfaces (handle) when performing the operation to prevent a shock to the operator, as seen in figure 5.
CAUTION:
The impact driver is not designed to be used as a drill.
DRIVING OR REMOVING SCREWS
See Figures 5 - 6, page 10.
 Place the direction of rotation selector in the correct
position for the operation.
 Hold the impact driver with one hand.
 Place the bit on the screw head and slowly depress the
switch trigger. Start the bit slowly for more control.
 As the screw is driven, impacting will begin.
8 — English