Technical Data - Proxxon SS 230 / E Manual Del Usuario

Key
1 Speed control knob
2 ON/OFF switch
3 Handle
4 Connection lead
5 Saw plate
6 Scale
7 Saw blade
8 Parallel stop
9 Piston with saw blade mount
Description of the machine
The PROXXON Super SS 230/E Jig Saw is the ideal
device for straight cuts and, above all, curved cuts in
wood (up to 12 mm), sheet metal (up to 5 mm) and
non-ferrous metals (up to 3 mm).
• Gearbox knob made from diecast aluminium
• Sliding foot for mitre cuts adjustable up to 45°
• Reduction gear and additional stroke rate control

Technical data

Dimensions, weight:
Length:
Weight:
Motor:
Voltage:
Power consumption Power rating:
Rotational speed
Noise emission:
Vibration:
Noise emission
Accessories (included):
4 Supercut saw blades for wood, plastic and metal.
1 Allen key
Accessories (included):
(for changing saw blade)
4 Supercut saw blades for wood, plastic and metal.
1 Allen key
1 Allen key
(for plate adjustment)
(for changing saw blade)
1 Allen key
(for plate adjustment)
- 8 -
230 mm
530 g
230 volts, 50/60 Hz
100 Watt 10 min 100 watt
≤ 70 dB (A)
1000 - 4500 min -1
< 2,5 m/s 2
LPA 87 dB(A)
LWA 100 dB(A)
Operation
Injury hazard
Safe and precise operation is only possible if the work
piece is securely fastened.
Clamping and changing saw blades
Injury hazard
Disconnect the mains plug before changing tools.
1. Loosen clamp screw using the Allen key 1 provided
(Fig. 2).
2. Insert saw blade (2) into slot in the saw blade mount
and re-tighten clamp screw.
Important
The saw blade must be located in the groove of the
support roller.
Setting the mitre angle
Injury hazard
Disconnect the mains plug before proceeding.
1. Loosen clamp screw using the Allen key 1 (Fig. 3).
2. Adjust the saw plate (2) to the desired mitre angle
and re-tighten the clamp screw.
Setting the parallel stop
Injury hazard
Disconnect the mains plug before changing tools.
1. Loosen clamp screw 1 (Fig. 4) using the Allen key
provided
2. Adjust the stop (2) to the desired dimension and
re-tighten the clamp screw.
The stop can also be used for curved cuts. For this
purpose, position a nail at the centre point of the curve
and use as axis for the stop. The scale for curved cuts
is on the back of the stop.
Danger!
Danger!
Danger!
Danger!
Note: