RHOSS MACROSYSTEM CCAM105 Instrucciones De Uso página 23

II.2.1.1 Installation of models with fans d=400–
500mm
INSTALLATION WITH VERTICAL AIR FLOW
The CCAM remote condensers with fans d=400-500mm are provided
with the electrical board not electrically connected to the fans of the
condenser; the electrical board must also be positioned as shown
below.
The electrical connection between the board and the fans must be
made according to the instructions provided on the adhesive label
located inside the board itself.
Fig. 3
INSTALLATION WITH HORIZONTAL AIR FLOW
The CCAM remote condensers with fans d=400-500mm are provided
with the electrical board not electrically connected to the fans of the
condenser; the electrical board must also be positioned as shown
below.
The electrical connection between the board and the fans must be
made according to the instructions provided on the adhesive label
located inside the board itself.
Fig. 4
SECTION II: INSTALLATION AND MAINTENANCE
For vertical installation, the electrical board must be installed as shown
in the figure. The unit and the electrical board must be fastened using
M10 screws. It is advisable to place anti-vibration material between the
unit and the support surface.
The unit and the electrical board must be fastened to the ground with
M10 screws as shown in the following figure. It is advisable to place
anti-vibration material between the unit and the support surface.
23