RS Pro RSHS800 Serie Manual De Uso página 15

Probe Compensation
It is necessary to properly compensate the probe at first use of it.
Non-compensated or inadequate compensated probe may cause
inaccurate measurement. The following steps are about probe
compensation:
1. Perform step 1, 2, 3 and 4 of "Function Inspection".
2. Check the displayed waveforms and compare them with figure
below.
under compensated
compensated
3. Use a nonmetallic
compensation adjustment hole on the probe until the waveforms
change to be correct as the figure "compensated correctly".
8
over
correctly compensated
driver to adjust the low-frequency
RSHS800
15