Switching On/Off; Switching The Laser/Working Light On/Off; Sawdust Blowing Function; Maintenance And Cleaning - Parkside PSTD 800 B2 Traducción Del Manual De Instrucciones Original

Switching ON/OFF

Switching the appliance on:
Press the ON/OFF switch
Switching the appliance off:
Release the ON/OFF switch
Switching to continuous operation:
Press the ON/OFF switch
position with the ON/OFF switch lock button
Switching off continuous operation:
Press the ON/OFF switch
Switching the laser/working light
ON/OFF
ON/OFF switch:
Press the ON/OFF switch
required function is active.
LASER and WORKING LIGHT → WORKING
LIGHT → LASER → SWITCH OFF

Sawdust blowing function

Switching the sawdust blowing function on:
♦ Slide the sawdust blower function switch
the position .
Supporting the extraction function:
♦ Slide the sawdust blower function switch
the position "0".
PSTD 800 B2
.
.
and lock it in this
.
and release it again.
for the until the
in
in

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work
on the appliance.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
WARNING!
■ If the supply cord of this power tool is dam-
aged, it must be replaced by a specially
prepared cord available through the service
organization.
■ Replace the saw blade
are too blunt for adequate sawing.
■ Clean the appliance after completing your
sawing work.
■ Remove any dirt (e.g. sawdust). If necessary,
clean the saw blade holder and the chip ejec-
tion opening with a brush or by blowing out
with compressed air.
as soon as its teeth
GB │ MT │
45 ■