Fitting The Splinter Guard; Fitting The Sliding Shoe; Use; Setting The Cutting Angle - Parkside PSTDA 20-Li A2 Traducción Del Manual De Instrucciones Original

Fitting the splinter guard

The splinter guard can prevent the tearing up of
the surface when sawing wood . The splinter guard
can only be used with certain sawblade types
without the sliding shoe
angle of 0° .
♦ Press the splinter guard
from below (notch facing upwards) .

Fitting the sliding shoe

When working on sensitive surfaces, you can fit
the sliding shoe on the baseplate
scratching the surface .
♦ Mount the sliding shoe
baseplate and press it up at the back until it
clicks into place on the baseplate
♦ To remove the sliding shoe
the rear of the baseplate
front .

Use

Setting the cutting angle

♦ Undo the clamping screws
hex key and pull the baseplate
♦ Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the baseplate
Push the baseplate
locking pin engages in the toothing
♦ Retighten the clamping screws
key .
■ 50
│ GB│MT
and only at a cutting
into the footplate
to prevent
onto the front of the
.
, unfasten it at
and slide it off the
with the supplied
to the rear .
forwards so that the
.
with the hex
NOTE
► When using a cutting angle of 15°/30°/
45°, the blade guard
guard must be detached beforehand .

Setting the stroke rate

The ON/OFF switch
trol . Press the ON/OFF switch
speed . Increasing the pressure increases the speed .
NOTE
► The integrated motor brake ensures rapid
stoppage .

Adjusting the pendulum stroke

♦ You can use the pendulum stroke switch
to adjust the pendulum movement of the saw
blade . You can achieve fine, clean-cut edges
without pendulum movement (setting "0") .
Deactivate pendulum movement when working
on thin workpieces . You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (settings 1–3) .

Switching on/off

Switching the appliance on:
♦ Push the safety lock-out
and keep it pressed .
♦ Press the ON/OFF switch
Once the saw is running, you can release
the safety lock-out
illuminates when the ON/OFF switch
depressed lightly or completely . This provides
illumination of the work area in poor lighting
conditions .
Switching the appliance off:
Release the ON/OFF switch
.
and the splinter
has a variable speed con-
lightly for a low
to the left or right
.
. The working light
is
.
PSTDA 20-Li A2