Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ABICUT 25K/45/75
Fault
Excess dross formation
Cutting nozzle burned
out
Strong electrode burn-out • Pressure drop while cutting due to
Tab. 8
Troubleshooting
11 Disposal
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards and guidelines.
BAL.0173 • 2018-09-28
Cause
• Cutting rate too low or too high
• Equipment parts worn or
damaged
• Output not adjusted
• Damaged or loose nozzle
• Contact with the workpiece
• Start of cut at the edge of the
workpiece too fast
• Too much spatter when punching
holes
• Pilot arc struck too long and too
frequently in the air
• Pilot arc too strong (depends on
the power source)
incorrectly set pressure monitor
• Loose electrode
• Pilot arc struck too long and too
frequently in the air
Troubleshooting
• Adjust the cutting rate
• Replace the equipment parts
• Adjust the output
• Hand-tighten the nozzle or
protective cap. Replace the nozzle
if necessary
• Avoid contact
• Start cutting at a lower rate
• Start at as great an angle as
possible and slowly insert
• Shorten/avoid ignitions in the air if
possible
• Set the pilot arc current to the
lowest possible value
• Correct the pressure monitor
setting
• Hand-tighten the electrode
• Shorten/avoid ignitions in the air if
possible
11 Disposal
EN - 15
Tabla de contenido
