Machine Anchoring; Direct-To-Finished-Floor Installation - Alliance Laundry Systems HC18MD2 Manual Del Instalacion

Installation

Machine Anchoring

Before anchoring the machine, refer to Table 1 to
determine the appropriate method of anchoring for the
machine.
NOTE: Improper installation may void the
warranty. Consult the manufacturer or distributor
before varying from a procedure.

Direct-to-Finished-Floor Installation

Installing with expansion bolts
(2 speed models only)
NOTE: Expansion bolts are not suitable for variable-speed machine installations. Expansion
bolts should not be used in single-machine concrete
foundation installations.
1. Verify the floor meets the requirements given in
the Machine Foundation section.
2. Verify that the mounting surface is level. If the
mounting surface fails to meet these
requirements, the machine must be installed
using J-bolts and machinery grout.
NOTE: If replacing a 35 pound machine with a
40 pound machine, note differences in cabinet size.
Refer to pages 12, 13 and 22.
3. Use the base of the machine as a template by
positioning the machine in the desired location
and marking the pre-drilled mounting holes on
the floor.
4. Set the drill depth gauge to 2-9/16 inches
(65 mm).
5. Drill the holes to the set depth. Refer to Figure 3.
6. Use compressed air or a squeeze bulb to clean out
each hole.
7. Install the machine anchors, using the included
tool.
8. Secure the machine to the floor, using the bolts
furnished with the anchors. Tighten the locknuts
by even increments – one after the other – until
all are tightened evenly and the machine is
fastened securely to the floor. Refer to Figure 4.
18 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Figure 3
Figure 4
The completed expansion bolt installation is shown in
Figure 5.
2
1
2-9/16 in.
(65 mm)
1 Washer
2 Locknut
3 Machine Base
4 5/8 in. (19 mm) Diameter Expansion Bolt
Figure 5
2-9/16 in.
(65 mm)
U137I
U137I
H029I
H029I
3
4
U138I
U138I
F232135