Machine Anchoring; Direct-To-Finished-Floor Installation - Alliance Laundry Systems HC18MD2 Instrucciones De Instalación

Machine Anchoring

Before anchoring the machine, refer to Table 2 to
determine the appropriate method of anchoring for the
machine.
NOTE: Improper installation may void the
warranty. Consult the manufacturer or distributor
before varying from a procedure.

Direct-to-Finished-Floor Installation

Installing With Expansion Bolts
(2 Speed Models, Fixed-Speed and
A-Control Variable-Speed Models)
NOTE: Expansion bolts are not suitable VNV
machine installations.
1. Verify the floor meets the requirements given in
the Machine Foundation section.
2. Mounting surface should be level and machine
must be properly grouted.
NOTE: If replacing a 35 pound machine with a
40 pound machine, note differences in cabinet size.
Refer to pages 20, 21 and 32.
NOTE: If replacing a 50 pound machine with a
60 pound machine, note differences in cabinet size.
Refer to pages 20, 21 and 32.
3. Use the base of the machine as a template by
positioning the machine in the desired location
and marking the pre-drilled mounting holes on
the floor. Metal templates are available at cost
through Alliance Laundry Systems. Refer to
Table 5 for ordering information.
4. Set the drill depth gauge to 2-9/16 inches
(65 mm).
5. Drill the holes to the set depth. Refer to Figure
11.
6. Use compressed air or a squeeze bulb to clean out
each hole.
7. Install the machine anchors, using the included
tool.
8. Secure the machine to the floor, using the bolts
furnished with the anchors. Tighten the locknuts
by even increments – one after the other – until
all are tightened evenly and the machine is
fastened securely to the floor. Refer to Figure 12.
F232135 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Figure 11
Figure 12
The completed expansion bolt installation is shown in
Figure 13.
2
1
2-9/16 in.
(65 mm)
1 Washer
2 Locknut
3 Machine Base
4 5/8 in. (19 mm) Diameter Expansion Bolt
Figure 13
Installation
2-9/16 in.
(65 mm)
U137I
U137I
H029I
H029I
3
4
CHM2032
CHM2032N
27