Light Kit Assembly; Important - Craftmade Ellington E-LAV44BP4LK Guia De Instalacion

10. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in center of fitter plate with loosened screws
in motor plate, allowing the male plug from
motor housing to come through hole in
middle of fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with Phillips
screwdriver. (diagram 1)
Remove 1 screw from post located on
underside of fitter plate and partially loosen
the other 2 screws on the other 2 posts.
Connect male plug from motor housing to
female plug from the light kit fitter. Make sure
plugs connect tightly. Align slotted holes in
light kit fitter with loosened screws in fitter
plate. Twist light kit fitter to lock. Re-insert
screw that was previously removed and
tighten all 3 screws securely. (diagram 2)
Install the 100-watt halogen bulb, type JD E11,
provided. (diagram 2)
Tip: Do not touch glass portion of bulb with
fingers or hands. Oil from skin can cause bulb to
overheat and go out prematurely. Use cardboard
box or foam wrapping bulb was packed with to
layer around glass portion of bulb.
Locate slots on glass shade and align with
nodules on light kit fitter (located on
underside of motor housing). Slide glass shade
onto light kit fitter and gently turn glass shade
in a clockwise direction until it slides into
place. (diagram 3)
IMPORTANT: The glass shade must be
removed in order to replace the bulb. When
you need to replace the bulb, please allow
bulb and glass shade to cool down before
touching. Use one 100-watt max. halogen
bulb, type JD E11, to replace the bulb, keeping
in mind not to touch the bulb itself as
described above (see "Tip").
motor plate
diagram 1
male plug
female plug
diagram 2
diagram 3
page 8
motor housing
fitter
plate
motor housing
light kit fitter
bulb
motor housing
light kit fitter
bulb
nodules
glass shade
fitter plate