Kits And Tools; Equipment Setup - Motorola PRO1150 Manual De Uso

PRO1150™ Service Manual
4. Outside housing, grasp accessory cover close to
"hinge".
5. Gently pull accessory cover away from housing.
To Install Accessory Cover:
1. Insert hinge tab into rectangular opening in
housing so accessory cover is flush with
housing. (Figure 3-12)
2. Inside housing, press on hinge tab until seated
in housing.
3. Press on accessory cover until flush.
To Remove Switch Lever:
1. Insert thin flat instrument between top of
switch lever and housing.
2. Gently pry top of switch lever away from
housing until "X-shaped" tab clears hole in
housing (Figure 3-13).
ÒX-shapedÓ tab
Housing Pin
PTT Lever
(side view)
Switch Lever Tab
holes
Figure 3-13
3. Gently pull lever toward top of housing to
release lever tabs.
To Install Switch Lever:
1. Align black monitor pad holes with housing
pins and insert.
2. Insert switch lever tabs through monitor pad
holes into housing (Figure 3-13).
3. Gently pull down to engage tabs.
4. Press firmly but gently on opposite end of lever
until "X-shaped" tab snaps in place.
English
Battery Cover Latches
To Remove Battery Cover Latches:
1. Slide battery cover latches toward open end of
housing into lock position (Figure 3-14).
Battery
Cover
Latch
Guide
2. Slide battery cover latches through "lock"
position out of latch guides.
To Install Battery Cover Latches:
1. Align battery cover latches with latch guides so
orange stripe is toward opening in housing.
2. Press into place through "lock" position to
"open" position.

Kits and Tools

Refer to Table 3-7 for kits and tools which make the
service and maintenance of the radios easier.

Equipment Setup

The proper configuration of service equipment for
the verification procedures is illustrated in
Figures 3-15 and 3-16.
Maintenance
Kits and Tools
Figure 3-14
3-5