Customising The Daily Programme - Gewiss Chorus EIB GW 10 791 Manual Del Usuario

To customise the preset daily programme, or modify the settings, press the
twice.
USER INSTRUCTIONS
P15 - Sending the HOLIDAY command to the slave
devices
When the P15 code appears on the screen, it is possible
to use the
the extension of the HOLIDAY command to the slave
devices to the timer-thermostat. Press the
within 30 seconds to confirm the value set.
The parameter setting procedure has now been completed.
Press the

Customising the daily programme

The message "PROG" is displayed on the screen, while
the bar of the first day of the week starts to blink.
Select the required day using the
Press the
selection.
After confirmation of the day, the current profile, relative
to the day selected, is displayed on the screen. The time
will start to blink.
Follow the steps below to customise the settings:
1 - select the starting time for the change in temperature
2 - set the new temperature set point
3 - completing the customisation process
1 - select the starting time for the change in
temperature
Use the
modifying the proposed profile is reached: the column
relative to the time selected will blink during the
increment of the time profile. The time is
decremented/incremented in steps of 15 minutes each
time the
define up to 4 programming periods each hour.
keys to enable (ON) or disable (OFF)
key to return to normal operating mode.
key within 30 seconds to confirm the
keys to modify the time until the time for
keys are pressed, so it is possible to
55
key
E
N
G
L
I
key
S
H
keys.