Gewiss Chorus EIB GW 10 791 Manual Del Usuario página 45

The activation of the heating or air-conditioning functions are indicated as followed:
GENERAL DESCRIPTION
The frostprotect. function is only enabled in heating
function mode, when the thermal regulation system is OFF.
In this case the timer-thermostat uses the set frostprotect.
temperature set-point, re-starting the heating system only
when the ambient temperature decreases below
T .
FROSTPROTECT
The message OFF and the measured ambient
temperature are displayed on the screen.
The high-temperature protection function is only
enabled in air-conditioning mode, when the thermal
regulation system is OFF.
In this case the timer-thermostat uses the set high-
temperature set-point, re-starting the air-conditioning
system only when the ambient temperature exceeds the
T
HIGH TEMPERATURE PROTECTION
The message OFF and the measured ambient
temperature are displayed on the screen.
Heating
The symbol indicates that the activation command has
been sent to the actuator which controls the boiler.
If the load notice has been sent via the ETS and the timer-
thermostat does not receive confirmation from the
actuator that the same has been activated, the
starts to flash. Subsequently, the timer-thermostat sends
the activation command again, at one minute intervals,
until it receives a positive response.
Air conditioning
The symbol indicates that the activation command
has been sent to the actuator which controls the air-
conditioner. If the load notice has been sent via the ETS
and the timer-thermostat does not receive confirmation
from the actuator that the same has been activated, the
symbol starts to flash. Subsequently, the timer-
thermostat sends the activation command again, at one
minute intervals, until it receives a positive response.
45
.
E
N
G
L
I
S
H
symbol