Gewiss Chorus EIB GW 10 791 Manual Del Usuario página 47

Heating
P01 - Set Point
heat
P02 - Set Point
heat
P03 - Set Point
heat
P04 - Set Point T
heat
P05 - Control logic
heat
If the control logic = proportional
P06 - Cycle time
heat
P07 - Proportional regulation
heat
differential value
P08 - Minimum percentage value for command sending
(visible if the 1 byte command format is selected via ETS)
If the control logic = 2 points
P09 - 2 point regulation
heat
differential value
P10 - Activation of self-learning function
heat
P13 Period of day/time sent to the slave devices
P12 PARTY command sent to the slave devices
P12 HOLIDAY command sent to the slave devices
To scroll the sequence, confirming the values displayed on the screen, press the
key until you reach the parameter you want to change.
Press the key again to exit the parameter setting procedure or it will exit
automatically after a 30" time-out.
It is necessary to perform both sequences to set the heating and air-conditioning
parameters (in the second sequence it is possible to confirm the parameters which are
the same, and just change the specific ones).
USER INSTRUCTIONS
Day of the week
Minutes
Temperature unit of measurement
.
FROSTPROTECT
P11 Enabling/Disabling of the master function
P12 Day/time sent to the slave devices
Hour
Air conditioning
P01 - Set Point
cond
P02 - Set Point
cond
P03 - Set Point Ts
cond
P04 - Set Point T
cond
P05 - Control logic
cond
P06 - Cycle time
cond
P07 - Proportional regulation
cond
differential value
P09 - 2 point regulation
cond
differential value
47
T P
HIGH EMPERATURE ROTECTION
E
N
G
L
I
S
H