Robern SCULPT Chamfer Manual Del Usuario página 9

Tabla de contenido
STEP 3 - PREP THE MIRROR
2. Remove the frame from it's packaging and align it over the back of the mirror. The four frame brackets should meet the outside face
of the tubing on the rear of the mirror. There should be some resistance as the brackets increase their contact with the tubing.
3. Press the brackets down onto the mirror tubing until the frame has come into complete contact with the back of the mirror tubing.
The brackets will NOT contact the back of the mirror.
Note: Do NOT pick up the mirror in this orientation by the frame.
THICKER RECTANGULAR
THICKER RECTANGULAR
FOAM FROM PACKAGING
FOAM FROM PACKAGING
2
Bracket
Adjusting the brackets: If the frame is not tight with the mirror, adjust the brackets toward each other evenly. Distances marked as "X"
should measure the same.
"X"
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
3
Adjust the Brackets evenly
9
Press down
"X"
Part no. 209-1308-rC rev. 08/29/19
Bracket
Screws
Sculpt
Tabla de contenido
loading

Este manual también es adecuado para:

Sculpt slim

Tabla de contenido