Tabla de contenido
STEP 2 - PREP THE WALL
1. The mounting location for the cleats are determined by the light pattern and width of the mirror. Use the diagrams on pages 5, 6, and
7 for the mounting location and number of cleats needed. Whether you are using two, three, or four brackets, you must mount the two
outer brackets to a structural frame member.
Must be mounted in
structural frame member
Up to 45"
(Two Brackets)
2. Level and mark the holes that determine the location of the cleats.
3A. Locate the studs and drill two holes for each cleat using a 3/32" drill bit.
3B. For the mounting brackets that do not require structural mounting (see views above), drill a 1/4" hole for each wall anchor and use
the supplied wall anchors.*
4. Use screws provided to attach cleats to the wall.
5. Tighten screws until tight. When anchors are used, keep turning screw at least 4 more times as shown to properly set anchor.
4X
*Actual wall anchor many differ from type shown.
6. Peel and stick the 3" adhesive locking strips to the wall in the locations indicated on pages 6 and 7.
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
Must be mounted in
structural frame member
45" up to 62"
(Three Brackets)
5
Must be mounted in
structural frame member
62" up to 72"
(Four Brackets)
Part no. 209-1308-rC rev. 08/29/19
Sculpt
Tabla de contenido
