Safety Precautions; Safety Information; Safety Symbols - koban KP 2203 Manual Del Usuario

Safety Precautions

Read these operation instructions
thoroughly and completely before
operating your meter. Pay particular
attention to WARNING.
The instructions in these warnings
must be followed.
• You must be careful when
working with voltages above
30V AC. Keep fingers behind the
probe barriers while measuring.
• Never use the meter to measure
voltages that might exceed the
maximum allowable input value
of any function measurement
mode.
• Always inspect your meter and
test leads before every use. If
any abnormal conditions exist:
broken test leads, cracked
cases, LCD not reading, etc,
do not attempt to take any
measurement.
• Using the meter with the
equipped test leads is only
conform to safety requirements.
If you need instead broken test
leads, you must replaced with
the same as type and electric
specification.
• Never touch a voltage source
when the test leads are plugged
into a current jack.
• Do not expose the instrument
to direct sunlight, extreme
temperature or moisture.
www.grupotemper.com
Phase digital power clamp meter
WARNING
Read the instructions before using
the instrument.

Safety Information

Three-phase digital power clamp
meter has been designed according
to IEC1010-1 and IEC1010-2-032
concerning safety requirements for
electrical measuring instruments
and handheld clamps with pollution
degree 2, overvoltage category
(600V CATⅢ).

Safety Symbols

Important safety information,
refer to the operating manual.
Dangerous voltage may be
present.
Earth ground
Double insulation (Protection
classⅡ)
Battery
Instructions manual |
KP 2203
33