Mounting Anti-Tip Bracket - Thermador PRO-HARMONY PRG30 Manual De Instalación

Left
Cabinet
• Prepare holes at fastener locations as identified below:
• For walls, wall studs, or floors composed of solid
wood or metal, drill 1/8" pilot holes.
• For walls or floors composed of drywall, sheet-rock
or other soft materials, drill 3/16" holes to a mini-
mum depth of 1-3/4", then tap plastic anchors into
each of the holes using a hammer.
• For walls or floors composed of concrete or con-
crete block, drill 3/16" holes to a minimum depth of
1-3/4", then tap concrete anchors into each of the
holes using a hammer.
• For walls or floors having ceramic tile covering, drill
3/16" holes through the tile only, then drill into the
material behind the tile as indicated immediately
above.
Figure 6: Anti-tip Bracket
Wall Line
Floor
Front Edge of
Right Cabinet
Right
Cabinet
X
typical -
either side
Figure 7: Placement of Anti-Tip Bracket (Top View)
• If the range is moved to a new location, the Anti-Tip
Device must be removed and reinstalled.

Mounting Anti-Tip Bracket

The alternative floor mounted bracket shall be installed as
follows:
1. Place bracket on floor in position shown in Figure 7
(Bracket may be used in either corner of the installation
area).
2. Secure to floor or wall stud.
3. Later, when the unit is installed, the adjustable leg will
slide under the bracket.
X
from edge of range
X = 4-1/2" (for 30" range)
X = 6-3/4" (for 36" range)
English 11