Nice MORX Instrucciones Y Advertencias De Instalación Y Uso página 7

SECTION - 6.A
EASY PROGRAMMING PROCEDURE
(for MORX + keypads)
l The procedure maps the command keys (▲ and ▼) to output-1 and output-2 on
the decoder as follows:
– command key ▲ maps to output-1;
– command key ▼ maps to output-2.
l The decoder's outputs (1 and 2) operate as momentaries; they are activated
when the key is pressed and deactivated as soon as it is released.
l The combination acts as the "access key" that must be programmed in accordance
with the user's needs. It is formed of up to nine digits, each in the range 0 to 9.
l EASY programming procedures allow you to program at most two different combi-
nations: one for output-1 (command key ▲) and the other for output-2 (command
key ▼). You can also program just one combination for both outputs (i.e. for both ▲
and ▼). • You can also cancel the memory using the key on the decoder. • EASY
programming offers no other functions.
PROCEDURES
6.A.1 Easy
To program a combination for command key ▲
(output-1) only
CAUTION! – This procedure is an alternative to that given in par. 6.A.3.
01. Press the decoder key: – the decoder will start beeping regularly. – The beeping
lasts for 30 seconds; within this time...
02. ...enter the desired combination (1 to 9 digits).
03. Then press ▲ twice.
6.A.2 Easy
To program a combination for command key ▼
(output-2) only
CAUTION! – This procedure is an alternative to that given in par. 6.A.3.
01. Press the decoder key: – the decoder will start beeping regularly. – The beeping
lasts for 30 seconds; within this time...
02. ...enter the desired combination (1 to 9 digits).
03. Then press ▼ twice.
6.A.3 Easy
To program a combination for both command keys: ▲
(output-1) and ▼ (output-2)
CAUTION! – This procedure is an alternative to that given in par. 6.A.1 and 6.A.2.
01. Press the decoder key: – the decoder will start beeping regularly. – The beeping
lasts for 30 seconds; within this time...
02. ...enter the desired combination (1 to 9 digits).
03. Then press ▲ and ▼ once each.
6.A.4 Easy
Cancelling the memory
This procedure cancels all data in the decoder's BM memory.
01. Hold down the key on the decoder: – the led will turn on for 3 seconds, then it will
flash 3 times;
02. release the key during the third flash. If the procedure is successful, after a few
moments the LED will flash 5 times.
You will now have to reprogram the decoder; you will also be able to choose between
the Easy and Professional programming modes.
English – 6