Nice MORX Instrucciones Y Advertencias De Instalación Y Uso página 12

6.B.21
Professional
To cancel the entire memory using the programming
password (reference digit: "0")
This procedure cancels all data in the decoder's BM memory.
01. Enter the programming password. – Press ▼ to confirm the password.
02. Enter the digit "0". – Press ▼ to confirm.
03. Enter "0" again. – Press ▼ to confirm.
04. Enter "0" a third time. – Press ▼ to confirm. If the procedure was successful, the
keypad will beep 3 times.
You will now have to reprogram the decoder; you will also be able to choose between
the Easy and Professional programming modes.
6.B.22 Professional
To cancel the entire memory without using the
programming password
This procedure cancels all data in the decoder's BM memory.
01. Hold down the key on the decoder: – the led will turn on for 3 seconds, then it
will flash 3 times;
02. release the key during the third flash. If the procedure is successful, after a few
moments the LED will flash 5 times.
You will now have to reprogram the decoder; you will also be able to choose between
the Easy and Professional programming modes.
11 – English
PROGRAMMING THE SYSTEM "MORX + TRAN-
7
SPONDER CARD READER"
7.1 - Using the system after the cards are programmed:
notes for the installer (read before programming the sys-
tem) and end user
l The use of the ETP reader is based on recognition of the unique code of each card
saved to the reader itself. When a card is held up to the reader, it sends it its ID
code; if this code is present in the ETP's memory, the reader activates output-1 or
output-2 (i.e. the output mapped to the card when it was programmed). If the card
is not saved to the reader, the reader emits 2 fast beeps to indicate an error.
l To control the automation, the user must have one (or more) cards which
have been saved to the reader, and the installer must provide him with the
following information:
OUTPUT-1, OUTPUT-2:
– the output (output-1, output-2, or both, 1 and 2)
the card activates when it is held up to the reader.
TYPE OF COMMAND:
– the command (e.g.: partial open, etc.) associated
with output-1 or output-2 of the reader. The command is executed by the automa-
tion when the card is swiped over the reader.
CARD MODE:
– the way in which the card must be swiped over the reader to
activate its output. The mode depends on the number of outputs the card can
activate.
l How to use a card that activates only ONE output
To activate output-1
•
Swipe the card over the reader: it beeps and immediately activates output-1.
To activate output-2
•
Swipe the card over the reader: it beeps and immediately activates output-2.
l How to use a card that activates BOTH outputs
To activate output-1
•
Hold the card in front of the reader: it beeps and, after 1 second, beeps again, then
immediately activates output-1.