Electric Connection; Gas Connection - De Dietrich DPE7549 Serie Manual De Instalación Y Utilizacion

1
•
INSTALLATION
1.2 - ELECTRICAL CONNECTION :
The appliance must be plugged in using
a standardized power cable with 3
conductors each 1.5 mm² ( 1 ph + 1 N +
ground) which must be connected to the
220-240V~ network by means of a
standardized IEC 60083 power socket or
a single-pole
compliance with installation regulations.
The plug must be accessible after the
hob is installed.
Cross section of the cable to be used
Cable H05V2V2F - T90 Three conductors, one
Cross section of
conductors in mm 2
Fuse
The protective conductor (green/ -
yellow) is connected to the earth
terminal on the hob and must also be
connected to the installation's earth
terminal . The fuse for the installation
should be 10 amperes (1.2.1).
If the supply cable is damaged, it must be
replaced by a cable or special set
available from the manufacturer or its
after-sales department.
cut-off device
220-240 V ˜ - 50 HZ
gas and mixed
of which is an earth
1
10 A

1.3 - GAS CONNECTION :

If the hob is to be installed above an oven
or if other nearby heating appliances
could heat and damage the gas hose,
then it is essential that a rigid pipe is
nstalled instead.
If a flexible hose is used (as is the case
in
of butane gas) then it must not be
installed in a place where it may be in
contact with a moving part of the kitchen
unit or a location likely to get cluttered.
No flexible hoses with a limited
service life may be longer than 2
metres and must be accessible for
inspection along their entire length. They
must be replaced before their expiry date
(printed on the hose). Whatever means
of connection is chosen, make sure that
it is gastight when installed, using soapy-
water. In France, you must use a hose or
pipe stamped NF Gaz
connection must comply
with the regulations in force in the country
where it is installed.
• Mains natural gas (1.3.1).
For your safety, you must choose only
one of the following three connections:
— Connection via a rigid copper pipe
with mechanical screw connectors (½"
gas standard).
• Connect directly on to the elbow on the
appliance.
.
24
The gas