0/ Identification; Fitting - De Dietrich DPE7549 Serie Manual De Instalación Y Utilizacion

0
•
IDENTIFICATION
Refer to the illustration 0.1.1..
1
•
INSTALLATION
Make a note of the references of your
appliance on the "After-Sales Service
and Customer Relations" page so that
you can readily find them in future (6.1.1).
This page also explains where to find
them on your appliance.
1.1 – FITTING :
This worktop must be at least 3 cm thick
and heatresistant or else coated with a
heat resistant material.
If a horizontal partition is installed under
the hob, it must be positioned at 10 cm
minimum below the worktop.
Under no circumstances keep any sprays
or pressurised
compartment below the hob (see "Safety
guidelines" chapter).
Follow the guidelines in the sketch
(1.1.1).
• Remove the "pan supports", burner
caps and burner heads, noting their
original positions.
• Turn the hob upside down and place it
carefully over the top of the base unit, so
as not to damage the knobs or igniters.
• To ensure a good seal between the
body of the hob and the worktop, stick the
foam seal A around the edge of the
body, before installing the hob (1.1.3).
containers in
• Turn over the hob place it over the
opening in the base unit.
•Fit the burner heads, caps and pan
supports.
Connect your hob to the gas (see "Gas
connection" section) and to the electricity
(see "Electrical connection" section).
•If you wish, you can secure the hob in
position, using the four fixing clamps
A and screws supplied (1.1.5) fixing
them to the four corners of the housing.
It is essential that you use the holes
provided for the purpose, as per the dra-
wing (1.1.4).
Stop screwing when the clamp starts
any
to bend.
Do not use a power screwdriver.
23