Instructions For The User; Using The Burners; Electric Plate Use - De Dietrich DTE1114X Manual De Instalación Y Utilizacion

INSTRUCTIONS FOR THE USER

It is necessary that all the operations regarding the installation, adjustment and
adaptation to the type of gas available are carried out by qualified personnel, in
conformity with the regulations in force.
The specific instructions are described in the booklet section intended for the
installer.

USING THE BURNERS

The symbols silk-screen printed on the side of the
knob indicate the correspondence between the
knob and the burner.
Automatic start-up with valves
Turn the corresponding knob anticlockwise up
to the maximum position (large flame, fig. 1) and
press the knob.
Fig.1
diameter of the pot is suitable for the burner
potential (see the following table), so as to avoid
that the flame goes out of the pot bottom (fig. 2).
Use the maximum capacity to quickly make the
liquids reach the boiling temperature, and the
reduced capacity to heat food or maintain boiling.
All of the operating positions must be chosen
between the maximum and the minimum ones,
never between the minimum position and the
closing point.
The gas supply can be interrupted by turning the
knob clockwise up to the closing position.
If there is no power supply, it is possible to light the
burners with matches, setting the knob to the start-
up point (large flame, fig.1).
Once the burner has
been started up, keep
the knob pressed for
about 6 seconds.
Using the burners
I n o r d e r t o o b t a i n
t h e m a x i m u m y i e l d
without waste of gas,
it is important that the
Fig.2
BURNERS
Auxiliary
Semi-rapid
Rapid
Triple crown
Notice
- When the equipment is not working, always check
that the knobs are in the closing position (see
fig.1).
- If the flame should blow out accidentally, the safety
valve will automatically stop the gas supply, after a
few seconds. To restore operation, set the knob to
the lighting point (large flame, fig. 1) and press.
- While cooking with fat or oil, pay the utmost
attention as these substances can catch fire when
overheated.
- Do not use sprays near the appliance in operation.
- Do not place unstable or deformed pots on the
burner, so as to prevent them from overturning or
overflowing.
- Make sure that pot handles are placed properly.
- When the burner is started up, check that the
flameis regular and, before taking pots away,
always lowerthe flame or put it out.

ELECTRIC PLATE USE

The electric-plate is operated with a seven position
switch and to turn the electric-plate on, rotate the
switch to any of the positions shown.
The red light is switched on when the electric-plate
is in operation.
Below as indicative basis, the settings to be used
for operating the electric-plate.
Warning
- Use only flat pans and with sufficiently thick base,
equal or not much superior than that of the plate.
- Do not switch the electric plate without the pan
over the plate.
- Do not cook any food on the plate surface.
- Turn off the plate few minutes before the cooking
end.
- After use the electric plate remains very hot for
a prolonged period of time, do not tuch it and do
not place any object on top of the plate.
- For a good preservation, the electric plate must
4
Power W Ø of pots
1000 10 - 14 cm
1750 16 - 18 cm
3000 20 - 22 cm
3800 24 - 26 cm