Emi Filter (Optional); Select Avg/ Qpeak Signal Detection Mode - Promax AE-966 Manual De Instrucciones

6.2.18

EMI Filter (Optional).

The optional EMI filter is used for specific measurement situations such as EMI
average detection, where higher level of sensitivity is required than the standard
configuration. When this module is installed, equipment gets two additional features:
Average/Quasi-peak detection mode, and 9k/120k RBW. For a new installation, contact
the service center.

6.2.18.1 Select AVG/ QPeak signal detection mode

Panel
1.- Press the Trace key.
operation
2.- Press F6 (More).
3.- Press F3 (Detection).
4.- The signal detection mode appears. When the
EMI filter is installed, F4 (AVG) and F5 (QPeak)
becomes available.
Parameter
AVG (average): Detects the average power level of the samples using a
low pass filter. Useful for smoothing the noise level.
QPeak (quasi-peak): Detects the quasi-peak power level of the
samples. Useful for viewing in zero span without missing signal
variations.
Page 142
USER'S MANUAL AE-966 / 967
Trace
More
Detection..
Normal
Sample
Peak+
AVG
QPeak
F 6
F 3
F 1
F 2
F 3
F 4
F 5
04/2016