The Transmitter; Installing The Transmitter Batteries; Driving Precautions - TLR TEN-SCT RTR Manual De Instrucciones

EN

The Transmitter

11 12 13
16 17
6
7
8
9
5
3

driving Precautions

• Maintain sight of the vehicle at all times.
• Inspect the vehicle for loose wheel hardware.
• Inspect the steering assembly for any loose hardware. Driving
the vehicle off-road can cause fasteners to loosen over time.
• Do not drive the vehicle in tall grass. Doing so can damage the vehicle
or electronics.
• Stop driving the vehicle when you notice a slow response from the throttle
or steering servo. Driving the vehicle when the LiPo receiver battery is
discharged can cause the receiver to power off. If the receiver loses
power, you will lose control of the vehicle. Damage due to an
over-discharged LiPo battery is not covered under warranty.
4
14 15 18
1. Steering Wheel: Controls direction (left/right) of the model.
2. Throttle Trigger: Controls speed and direction (forward/brake) of the model.
3. R.O.S.S. Button: Used with vehicles featuring the R.O.S.S. Remote Start System.
4. Antenna: Transmits signal to the model.
5. On/Off Switch: Turns the power on/off for the transmitter.
6. Indicator Lights: G reen (right) light indicates adequate battery power.
7. ST. Trim: Adjusts the "hands off" direction of the model.
8. TH. Trim: Adjusts the motor speed to stop at neutral.
9. Steering Dual Rate: Adjusts the amount the front wheels move when the steering
4
10. Bottom Cover: Covers and holds the batteries that power the transmitter.
11. BIND Button
12. ST. REV: Reverses the function of the steering when the wheel is turned left or right.
13. TH. REV: Reverses the function of the speed control when pulled back or pushed
14. TH-F: Forward Endpoint. Adjusts the amount of full throttle.
15. TH-B: Brake Endpoint. Adjusts the amount of full brake.
16. ST-L: Steering Left Endpoint. Adjusts the amount of left steering travel.
17. ST-R: Steering Right Endpoint. Adjusts the amount of right steering travel.
18. Throttle Limiter: Limits the throttle to High (100%), Medium (75%), or Low (50%).
1
2
10
Red (left) indicates signal strength.
wheel is turned left and right.
forward.

Installing the Transmitter Batteries

1. Push in the battery cover a small
amount to release the retaining tab,
then remove the cover.
2. Install 4 AA batteries, taking care to
align battery polarity to the diagram
in the transmitter's battery case.
3. Carefully reinstall the battery cover
by aligning the tabs with the slots
on the transmitter.
CauTIoN: NEVER remove the transmitter batteries while the vehicle is
powered on, as loss of control, property damage or injury may result.
CauTIoN: Do not discharge a LiPo battery below 3V per cell.
Batteries discharged to a voltage lower than the lowest approved voltage
may become damaged, resulting in loss of performance and potential
fire when batteries are charged.
• Do not apply forward or reverse throttle if the vehicle is stuck.
Applying throttle in this instance can damage the engine or clutch.
• After driving the vehicle, allow the engine and electronics to cool
to ambient temperature before driving the vehicle again. Remove
the body of the vehicle to reduce the cooling time.
TLR TEN-SCT RTR • INSTRuCTIoN maNuaL