Blodgett SG3240 Serie Manual Del Operario página 20

Installation
Oven Assembly
OPTIONAL REMOTE COMPUTER CONTROL
1. Remove all screws and disassemble operator
control and mounting bracket assembly from
the housing.
2. One end of the remote cable is shipped at-
tached to the oven. Push the other end of the
cable through the access hole in the lower
right side of the mounting bracket assembly
until the strain relief rests against the side of
the bracket.
3. Thread the end of the cable through a locknut.
Tighten the locknut to the strain relief.
4. Attach the cable connector to the circuit
board.
5. Use the mounting bracket as a template to
mark the location for installing mounting bolts
into the wall.
NOTE: Up to 1/4" diameter bolts can be used.
The bolt type should be determined by
the wall construction.
Operator
Control
6. Attach the mounting bracket to the wall using
the mounting bolts.
7. Slide the remote housing over the mounting
bracket. The holes on the sides of the housing
must line up with the holes on the sides of the
bracket. The control cable will line up with the
large slot in the mounting bracket.
8. Secure the housing to the mounting bracket
with the screws removed in step 1.
9. Insert the operator control into the housing.
Secure the control with the screws removed in
step 1.
Remote
Housing
Figure 17
18
Remote Mounting
Bracket Assembly